Here GPS


Topic Replies Activity
Here 2 can update

Here2 CAN Mode Instruction Here2 Default factory setting is CAN mode with UAVCAN Protocol. Default Here2 CAN mode has three devices on CAN bus: GPS, magnetic compass, and barometer. The safety switch is not workable und…

179 November 25, 2019
About the Here GPS category 1 December 26, 2018
Here 2 Bricked on firmware update 4 December 8, 2019
KORE Board -- Here2 (GPS2) Connected to the GPS2/i2c2 port 2 December 8, 2019
Firmware upgrade in GPS RTK Here+ without USB nor SW connectors 6 December 4, 2019
Here V2 and Hereflow CAN updates 2 December 3, 2019
Here 2 Critical Bad Compass Error 10 November 25, 2019
Here 2 GPS UAVCAN Advantages Over I2C Connection Through GPS1 35 November 25, 2019
Here+ does not "hold" RTK Fixed status reliably - Help please! 53 November 23, 2019
Here2 barometer 12 November 22, 2019
HERE2 issue >> GPS 1: u-blox navigation rate configuration 0x1DFF 18 November 22, 2019
Moderate change in mag_field (27.29%) 4 November 20, 2019
CAN HERE2, Unable to see GPS or use SLCAN for update 3 November 19, 2019
Here2 and cube orange - calibration fails 1 November 16, 2019
Cube black and 2pc Here+ .Setup in Missionplanner 11 November 13, 2019
Here2 board hw issues and config for cube black 2 October 16, 2019
Here2 CAN vs i2c 6 October 16, 2019
Here 2's Compass at COMPASS_DEV_ID3 6 October 15, 2019
HERE2 GPS multiple problems 6 October 14, 2019
Here2 only power light working 8 October 12, 2019
Here2 mounting holes and diameter 4 October 4, 2019
GPS Cable extension for HERE 2 7 October 4, 2019
CubePilot cryptographic Modules. What are they for? 7 October 3, 2019
Here 2 UAV CAN Safety Switch 5 October 1, 2019
"Please use CAN as your primary GPS" 12 October 1, 2019
Here 2 GPS Orientation 5 September 30, 2019
Here2 stady green Led after update 13 September 30, 2019
Repackaged Here2? 6 September 25, 2019
Upgrade Here 2 firmware 16 September 24, 2019
HERE2 CAN issue 52 September 19, 2019