New RTK system with Here Pro

Hello!

I’m currently working on a project involving an ArduCopter-based drone with RTK capabilities. In our previous setup, we used an Emlid RS2 as the RTK base and an RFD900X telemetry radio to transmit correction data, with a laptop acting as the bridge.

To optimize the system and reduce components, we’re planning the following setup:

  • On the drone (Rover):
    • HerePro as the primary GPS and RTK rover
    • RFD900X as the receiver of RTK corrections
  • On the base station:
    • Emlid RS2 as the RTK base
    • RFD900X as the transmitter of RTK corrections

Since information on this specific configuration is limited online, and we currently use a Here4 (without RTK), it’s been difficult to test. We’re aiming for a laptop-free correction link, sending RTCM data directly from the RS2 through the RFD900X to the drone.

Is it possible to configure the HerePro to receive RTCM corrections via a serial interface (USB)? Maybe changing SERIAL to CAN?

Any guidance on the required configuration or wiring would be greatly appreciated!