# New to Pixhawk 2.1

**URL:** <https://discuss.cubepilot.org/t/new-to-pixhawk-2-1/2878>\
**Category:** Cube Autopilot\
**Created:** [23 February 2020 19:08 UTC](https://discuss.cubepilot.org/t/new-to-pixhawk-2-1/2878 "2020-02-23T19:08:23Z")\
**Posts on this page:** 4\
**Page:** 1

<div class="post-metadata">

**Author:** ![rjriggins111](https://discuss.cubepilot.org/letter_avatar_proxy/v4/letter/r/eb8c5e/32.png) [@rjriggins111](https://discuss.cubepilot.org/u/rjriggins111)\
**Post date:** [23 February 2020 19:08 UTC](https://discuss.cubepilot.org/t/new-to-pixhawk-2-1/2878/1 "2020-02-23T19:08:23Z")

</div>

My first question is about the Warning banner I get at the top of the page here. It says to enter certain parameters in order for safe, redundant flight. Are these parameters covered in recent firmware updates or do I need to enter them manually?

Rick

---

<div class="post-metadata">

**Author:** ![MadRC](https://discuss.cubepilot.org/user_avatar/discuss.cubepilot.org/madrc/32/2088_2.png) [@MadRC](https://discuss.cubepilot.org/u/MadRC)\
**Post date:** [23 February 2020 23:40 UTC](https://discuss.cubepilot.org/t/new-to-pixhawk-2-1/2878/2 "2020-02-23T23:40:15Z")

</div>

Yes if you have a new Cube and install the latest ArduPilot these will all be preset as long as you select the correct version to install.

Note that the cube now comes blank with no firmware onboard so when you get it you will need to install the latest ArduPilot via mission planner ideally.

---

<div class="post-metadata">

**Author:** ![rjriggins111](https://discuss.cubepilot.org/letter_avatar_proxy/v4/letter/r/eb8c5e/32.png) [@rjriggins111](https://discuss.cubepilot.org/u/rjriggins111)\
**Post date:** [24 February 2020 02:12 UTC](https://discuss.cubepilot.org/t/new-to-pixhawk-2-1/2878/3 "2020-02-24T02:12:11Z")

</div>

It worked just fine until I did a reboot after the firmware and Mission Planner updates. Now I get an error message saying to "Check BRD\_TYPE:Unable to initialize - sensor. Not really sure what this means. The board type is set to “3” for Pixhawk as per SB2.

By the way, what do you mean by selecting the right version. Do you mean choose “Cube Black” where it says Cube Black?

---

<div class="post-metadata">

**Author:** ![mgrimes1907](https://discuss.cubepilot.org/letter_avatar_proxy/v4/letter/m/3e96dc/32.png) [@mgrimes1907](https://discuss.cubepilot.org/u/mgrimes1907)\
**Post date:** [24 February 2020 03:39 UTC](https://discuss.cubepilot.org/t/new-to-pixhawk-2-1/2878/4 "2020-02-24T03:39:52Z")

</div>

When did you purchase your Cube
