5 Volt I2C and Serial Insufficient

I am trying to get a Benewake Lidar TF02 working on CUbe Black w/ standard carrier board.
Everything powers up fine with the lidar unplugged. Disconnect power and plug lidar into Telemetry 2 port and red light comes on Here 2 GPS and lights on the side flash white a few times and then everything goes out.

Is there a way to correct this problem without hacking the wires and powering externally or buying a Mauch power supply?

Power benewake from bec. It’s all over the internet everywhere. Flight controler is not a powersupply.

1 Like


1 Like