Camera gimbal unable to pan and tilt

Mission Planner
1

Hello,

I have my gimbal PAN and Tilt Control wires attached to auxiliary port one and port two on my carrier board. I set both servo9_ Function and servo10_ Function=1 for RCpass Thur. I also mapped my Transmitter to the appropriate slide switches. Some reason I am unable to get my gimbals pan and tilt to function. The gimbal I am Using is the Tatot TL3D02.

Any suggestions on how to get the pan and tilt the function?

Your assistance is greatly appreciated.

Thank you,
Michael

2

Have you checked the gimbal connected to an RX? Let’s make sure the gimbal works first.

3

I’ll give that a try it had work before I’m sensing that I made some changes that affected the Aux ports. I’ll double check all my configurations.