Cube and Air Speed Sensor

Cube Autopilot
1

Is there any documentation out there explaining how to program and wire an analog speed sensor as shown below to PixHawk 2.1 Cube?

2

https://ardupilot.org/plane/docs/airspeed.html
If you have MS4525 or MS5525 on I2C, just plug it in I2C port. It’s similar to Pixhawk.

3

It’s not that simple. Just plug it in. You have to set parameters. If you read my post I said analog, not I2C.

4

Of course you have to set parameters. That’s why I have attached the link. Go through it and get back.