FailSafe settings for Air Unit loss of reception

In my “conventional” control radios (FrSky, Team Blacksheep Crossfire, etc.) there’s always a failsafe setting for what the receiver should do upon loss of signal from the transmitter.

Typically, this is set to “no pulses.”

I haven’t seen a setting for this yet in the HereLink docs or the HereLink firmware screens.

Since the RC link, the telemetry and the video are all on the same “link” - I’m guessing that the ArduPilot setting for the failsafe for loss of connection to the Ground Control Station will have to be considered in terms of the HereLink architecture.

If someone could offer some advice and information on this topic, that would be much appreciated.

Thank you.

herelink uses no pulses on the sbus port.