Hi everyone, this is my first project with herelink, I’m asking for your help. Already after I built the drone, installed and configured everything, then I went to customize herelink. What is the task. I have herelink airunit and herelink remote. And the ground station is my PC with Linux. I have Zerotier installed on the remote and PC. The network is configured correctly, ip is pinged. But when I configure QGC on my PC, connecting to herelink via UDP or TCP, nothing happens. I thought the problem was with zerotier and tried tailscale, but that didn’t help either. On the local network everything works correctly, but I don’t need that. When connecting via TCP I get an error (photo below). And when I connect via UDP then nothing happens, only this data comes to the column mavlink in QGC (photo below). I ask your help, where did I make a mistake?
