Prearm safety check Fail: No Backend Driver

Cube Autopilot
1

Hello All

I have assembled my Cubepilot Orange + and in Ardupilot, I get a Pre-arm failure message “Generator: No Backend Driver”

Looking at the Description in the Ardupilot Website, it states “Firmware does not include selected generator”

How can I get past this - Any help will be appreciated. I am also new to the builds so not experience with programming etc.

2

its either a parameter you have set by accident if you do not have a generator fitted, in which case… load plane then copter to reset all parameters.

Or you are trying to support an unknown generator.

check the answers on the link I sent

3

Thank you Philip.

It is resolved