I experience a similar problem. I’m also trying to install HPG 1.40 on the Here+ V2 Rover. I can connect to u-center fine, the Rover and USB light up blue and red respectively. However, when I try to install the firmware, the following text will come up and ends in a red screen (side note - I’ve used all baudrates):
Starting Flash Firmware Update
Loading and checking firmware image
Load FW binary ‘C:\Users\atomi\Downloads\NEO-M8P-FW301-HPG140_RNwithFW\DO_EXT_301_HPG_140_ROVER.91bbd17d889e0fe40c2d823991595224.bin’
Binary check success, G80 image valid.
Version: 3.01 (db0c89)
FLASH Base: 0x800000
FW Base: 0x800000
FW Start: 0x86A261
FW End: 0x87ACC0
FW Size: 0x7ACC8
Transfer Packetsize: 512
Transfer Packets: 983
Sending training sequence
Checking communication link…
Timeout #1, retrying
Checking communication link…
Timeout #2, retrying
Checking communication link…
Timeout #3, retrying
Checking communication link…
Communication not possible, wrong baudrate?
Done in 6.4 sec.
Statistics:
Erases sent: 0
Writes sent: 0
Erase timeouts: 0
Write timeouts: 0
Settings:
