Hi guys,
Long time follower, first time poster.
I ran into an issue with my cube blue (pretty sure it’s the same as a cube orange but in case I’m wrong I thought I’d specify) and my Here3 GNSS receiver. I’m running Ardupilot 4.5.7 and Mission Planner GCS. Here3 is running version 1.8. When I initially power on the aircraft, the Here3 blue LED lights flash a few times then the receiver goes dark. If I unplug the Here3 from CAN1 and plug back in, the receiver goes to flashing yellow and eventually a 3DFIX with Green LEDs. I’ve seen a few posts about this a couple of years ago and have tried the suggestions in those posts with no positive results. I’ve tried setting BRD_BOOT_DELAY to 5seconds, and changing CAN ID value. Not really sure what else to try other than using another firmware version. Does anyone know the reason for this issue and/or have a resolution? I’d really appreciate any help the community has to offer. Thank you