Cube Autopilot


Topic Replies Activity
About the Cube Autopilot category 2 January 6, 2019
No yaw control 8 September 17, 2019
EKF2 inconsistent YAW 21-93 degrees 9 September 16, 2019
2018 manufactured black cube with NuttX os 4 September 15, 2019
Orange Cube Firmware 3 September 15, 2019
Kore Carrier Board 2 September 14, 2019
Copter: onboard mag calibration does not start if HereFlow is used 9 September 14, 2019
Cube Orange Firmware 9 September 14, 2019
New Carrier Board 8 September 14, 2019
HexaCopter with 5 or 4 motors 9 September 13, 2019
Batt_Volt_Mult issue and inconsistent Voltage reading 3 September 12, 2019
Yellow Cube Firmware Issue 8 September 11, 2019
Place to send a cube fix? 2 September 10, 2019
Disable GCS failsafe when in Manual Mode 5 September 10, 2019
Cube Blue and Black IMU pitch oscillation 5 September 6, 2019
Uncommanded Ascent 18 September 6, 2019
DJI E5000 propulsion system compatibility with the Cube 6 August 31, 2019
Use all sensors on Cube Black + 2 Here2 GPS 8 August 27, 2019
Unable to connect with QGC with Pixhawk Cube 2.1 7 August 27, 2019
Facing issues with DISARMING ON LANDING 3 August 26, 2019
Drone stops during mission, floats around does not respond to RTL 6 August 24, 2019
Toilet bowl with 2.1 black cube! 24 August 24, 2019
"fmuv3" vs "CubeBlack" firmware 25 August 22, 2019
[Solved] Your board has a Critical 3 August 21, 2019
Mini carrier board can question 1 August 20, 2019
Can newer cube be used in 3DR solo? (does it have 5v PWM) 11 August 19, 2019
Compass variace & in-flight yaw alignment 5 August 19, 2019
Please help to run Motor test using Mission Planner and PX 2 August 16, 2019
Camera on/off function using relay on Cube autopilot 4 August 10, 2019
Orange & Yellow Beta Cubes - Firmware Issues 33 August 10, 2019